COMPARISON OF NITROGEN-DOPED PHOTOCATALYTIC SURFACES SYNTHESIZED BY PVD AND SOL-GEL METHODS

  • Erhan Ozkan Dikkan R&D Center, Izmir, Turkey
Keywords: TiO2, sol-gel, PVD, photocatalysis, thin film

Abstract

The aim of this study was to produce photocatalytic TiO2–xNx coatings that can be active in visible light using different methods. Physical vapour deposition (PVD) and sol-gel methods were preferred for these coatings. Thin films were synthesized by dip coating on a glass substrate using the sol-gel method. In addition, thin glass film coatings were obtained by applying an arc for one minute to the glass films using the PVD method. Since the coating phase is important in terms of photoactivity, a phase analysis was performed using XRD. The obtained surfaces will be used in antibacterial applications. Therefore, the thickness of the coatings was determined with the X-Ray refraction method, and their optical band gap was measured. Based on these values, it was observed that nitrogen has a reducing effect on the optical band gap in titanium oxide-based coatings. The aim of nitrogen doping was to enhance photoactivity by adding an additional band between the valence band and conduction band of a photocatalytic surface. After these experiments using rhodamine-B and methylene blue solutions, specimens’ photocatalytic effects under fluorescent, sun and UV light were tested. It was determined that nitrogen’s decreasing effect on the optical band gap results in increased photoactivity with both PVD and sol-gel techniques. In addition, it was found that the coatings made with PVD exhibited a more controlled structure in a shorter time, while the production of sol-gel coatings was a much cheaper method, with low investment costs.

References

1Akman, Beyza, et al. "Gıda ve Sağlık Uygulamaları İçin UV-A Işıma Altında Alternatif Bir Fotokatalizör Olarak: Doğal Melanin Nanoparçacıkları." Avrupa Bilim ve Teknoloji Dergisi 32 (2021): 940-946.
2Altıntaş Yıldırım, Ö., Gökçe, İ., Yıldırım, M. C., Ünalan, H. E., Sönmezoğlu, S., & Öztürk, T. "Yeni nesil Zn2SnO4–GO–M (M: Mn, Co) foto katalizör kompozit yapıların sentezi, karakterizasyonu ve antibakteriyel özelliklerinin incelenmesi." (2019): 101-123.
3Bulut, M., and Birben, Ü. "AB Su Çerçeve Direktifinin Türkiye’de su kaynakları yönetimine etkisi." Turkish Journal of Forestry 20.3 (2019): 221-233.
4Dalkılıç, Feride. Gözenekli cam üzerine immobilize edilmiş nadir toprak iyonu katkılı TiO2 ile sulardan boyar madde giderimi. MS thesis. Konya Teknik Üniversitesi (2022): (17-35)
5Dewi, Yolanda. Sintia. "Sintesis dan karakterisasi fotokatalis TiO2 mesopori terdoping galium (III) dengan variasi konsentrasi dopan Ga3+ menggunakan metode sonikasi. Diss." Universitas Islam Negeri Maulana Malik Ibrahim (2019): 103-120.
6Dutta, Vishal, et al. "An overview on WO3 based photocatalyst for environmental remediation." Journal of Environmental Chemical Engineering 9.1 (2021): 105018.
7Guo, Qing, et al. "Fundamentals of TiO2 photocatalysis: concepts, mechanisms, and challenges." Advanced Materials 31.50 (2019): 1901997.
8Güner, Eda KELEŞ. "Kobalt Ferrit Nanoparçacıkların Sentezi, Karakterizasyonu ve Fotokataliz Uygulamaları: Farklı Çöktürücü Maddelerin ve Yöntemlerin Etkisi." Journal of the Institute of Science and Technology 13.1 (2023): 432-447.
9Huang, Zhuquan, et al. "Insight into the real efficacy of graphene for enhancing photocatalytic efficiency: a case study on CVD graphene-TiO2 composites." ACS Applied Energy Materials 4.9 (2021): 8755-8764.
10İzgi, Mehmet Sait, et al. "Etkili Aktif Karbon Destekli Cds Fotokatalizörlerin Fotokatalitik Uygulamaları." Bitlis Eren Üniversitesi Fen Bilimleri Dergisi 9.2 (2020): 662-670.
11Liu, Xiangyu, et al. "Hollow CdS-based photocatalysts." Journal of Materiomics 7.3 (2021): 419-439.
12Magdalane, C. Maria, et al. "Synthesis and characterization of TiO2 doped cobalt ferrite nanoparticles via microwave method: Investigation of photocatalytic performance of congo red degradation dye." Surfaces and Interfaces 25 (2021): 101296.
13Mohammed, Mustafa KA. "Sol-gel synthesis of Au-doped TiO2 supported SWCNT nanohybrid with visible-light-driven photocatalytic for high degradation performance toward methylene blue dye." Optik 223 (2020): 165607.
14Özdoğan, Nizamettin, and Kadir Özdemir. "İçme suyu kaynaklarındaki trihalometan oluşumunun incelenmesi." Avrupa Bilim ve Teknoloji Dergisi 17 (2019): 776-785.
15Özgür, Cihan. "Dezenfeksiyon ünitesi risk analizi: içme suyu arıtma tesisi." Niğde Ömer Halisdemir Üniversitesi Mühendislik Bilimleri Dergisi 10.1 (2021): 16-22.
16Pamela Luberty Sinaga, Sisi. Studi Pengaruh Rasio Dopan. Fe2O3 dan Temperatur Kalsinasi Terhadap Karakteristik Komposit TiO2/Fe2O3 sebagai Material Fotokatalis. Diss. Universitas Brawijaya (2021).
17Pant, Bishweshwar, Mira Park, and Soo-Jin Park. "Recent advances in TiO2 films prepared by sol-gel methods for photocatalytic degradation of organic pollutants and antibacterial activities." Coatings 9.10 (2019): 613.
18Patial, Shilpa, et al. "Tunable photocatalytic activity of SrTiO3 for water splitting: strategies and future scenario." Journal of Environmental Chemical Engineering 8.3 (2020): 103791.
19Vahl, Alexander, et al. "Pathways to tailor photocatalytic performance of TiO2 thin films deposited by reactive magnetron sputtering." Materials 12.17 (2019): 2840.
20Wang, Yu-Hsiang, et al. "A review on the pathways of the improved structural characteristics and photocatalytic performance of titanium dioxide (TiO2) thin films fabricated by the magnetron-sputtering technique." Catalysts 10.6 (2020): 598.
21Yaqoob, Asim Ali, et al. "Advances and challenges in developing efficient graphene oxide-based ZnO photocatalysts for dye photo-oxidation." Nanomaterials 10.5 (2020): 932.
22Zhang, Xuqiang, et al. "Boron substitution enhanced activity of BxGa1− xAs/GaAs photocatalyst for water splitting." Applied Catalysis B: Environmental 300 (2022): 120690.
23Gombac, V., DeRogatis, L., Gasparotto, A., Vicario, G., Montinia, T., Barreca, D., Balducci, G., Fornasiero, P., Tondello, E. and Graziani, M. "TiO2 nanopowders doped with boron and nitrogen for photocatalytic applications." Chemical Physics 339 (2007): 111–113.
24Hanaor, D.A.H., Sorrell, C.C. "Review of the anatase to rutile phase transformation." Journal of Materials Science, 46 (2011): 855-874.
25Zhang, H.Z., Banfield, J.F. "Thermodynamic analysis of phase stability of nanocrystalline titania." Journal of Materials Chemistry 8 (1998): 2073-2076.
26Gombac, V., DeRogatis, L., Gasparotto, A., Vicario, G., Montinia, T., Barreca, D., Balducci, G., Fornasiero, P., Tondello, E. and Graziani, M. "TiO2 nanopowders doped with boron and nitrogen for photocatalytic applications." Chemical Physics 339 (2007): 111–113.
27Zaleska, A., Sobczak, J. W., Grabowska, E. And Hupka, J. "Preparation and photocatalytic activity of boron-modified TiO2 under UV and visible light." Applied Catalysis B: Environmental 78 (2008): 92–100.
28Houas, A., Lachheb, H., Ksibi, M., Elaloui, E., Guillard, C. and Herrmann, J.M. "Photocatalytic Degradation Pathway of Methylene Blue in Water." Applied Catalysis B: Environmental 31 (2001): 145–157.
29Xu, J. H., Li, J., Dai, W. L., Cao, Y., Li, H. and Fan, K. "Simple fabrication of twist-like helix N, S-codoped titania photocatalyst with visible-light response." Applied Catalysis B: Environmental 79 (2008): 72–80.
Published
2024-12-05
How to Cite
1.
Ozkan E. COMPARISON OF NITROGEN-DOPED PHOTOCATALYTIC SURFACES SYNTHESIZED BY PVD AND SOL-GEL METHODS. MatTech [Internet]. 2024Dec.5 [cited 2026Oct.11];58(6):775–781. Available from: https://mater-tehnol.si/index.php/MatTech/article/view/1132